SVA Smoke Vent Introduction
Acudor Smoke Vents are designed to provide an economical solution for fire ventilation by removing deadly smoke, heat, and gases from a burning building. Double leaf Smoke Vents are used for smaller areas that need venting, including elevator shafts and stairwells. Single leaf units are not U.L. Listed.
-
Cover
Double-skin construction (“in box type design”) with 1" cellulose insulation and a continuous EPDM foam weather/draft seal gasket that is attached to the inside of cover to provide a flush, tight fit. Designed to support a live load of 40lbs./sq. ft., the cover is 11 gauge aluminum with a 20 gauge aluminum inside liner. -
Curb
1/8" Aluminum with 1" thick fiberboard roof insulation at curb exterior. Curb is 12" high, with 3.375" wide bottom flange and pre-drilled mounting holes. -
Hinge
Heavy duty galvanized steel / aluminum pintle hinges with 3/8" pin -
Opening
Gas spring operators allow cover to open and close with ease. Inside and outside release allows for manual lid operation. -
Door Latch
Self latching Slam Latch. Supplied standard with 165° UL Listed Fusible Link. Resettable McCabe link available. -
Finish
Mill Finish
Roof Hatches & Smoke Vents
Product Downloads
| Product Information | Submittal Drawing | DWG | 3D View | BIM_ | Archicad | |
|---|---|---|---|---|---|---|
|
SVA Smoke Vent
|
|
|
|
|
|
|
Product Highlights
1/8" thick aluminum
12" high insulated curb
High performance gas springs
Inside and Outside manual release
UL Listed Fusible or McCabe Resettable Link
Request Information
Do you have a question regarding our products? Do you need more information for your project?
Please don’t hesitate to reach out, we’re here to help!
