RHG-SEC Security Roof Hatch Introduction
Acudor Security Roof Hatches are designed to provide convenient, economical access to the roof of a building while adding an additional level of security. The heavy gauge materials used to manufacture this hatch are ideal for applications in banks, prisons, hospitals and more.
-
Cover
Double-skin construction (“in box type design”) with 1" Polyiso (R-6) insulation and a continuous EPDM foam weather/draft seal gasket that is attached to the inside of cover to provide a flush, tight fit. Designed to support a live load of 40lbs./sq. ft., the cover is 10 gauge galvanized steel with a 18 gauge galvanized steel inside liner. -
Curb
10 gauge galvanized steel with 1" thick Polyiso (R-6) insulation with Fiberglass liner at curb exterior. Curb is 12" high, with 3.375" wide bottom flange and pre-drilled mounting holes. -
Hinge
Heavy duty galvanized steel pintle hinges with 3/8" SS pin -
Opening
Gas spring operators allow cover to open and close with ease. Stainless Steel inside pull handle allows for easy control when closing cover. -
Door Latch
Self latching, zinc plated outside T handle with stainless steel inside lock and lever assembly. Heavy duty detention lock with paracentric key. Unit also has inside and outside padlock provisions. -
Finish
Material is prepared with an iron phosphate wash, followed by a rust inhibiting primer, and then a baked on polyester enamel paint.
Roof Hatches & Smoke Vents
Product Downloads
| Product Information | Submittal Drawing | DWG | 3D View | BIM | Archicad | |
|---|---|---|---|---|---|---|
|
RHG-SEC Security Roof Hatch
|
|
|
|
|
|
|
Product Highlights
